But How About Incompressible Data and TRIM?

I mentioned earlier that TRIM has never functioned properly in SandForce SSDs when the drive is tortured with incompressible datam, which has never been a strength of SandForce. When it faces some, it's not exactly sure what to do with it. Your data will of course be written just like compressible data, but when your whole design is based on the assumption that the data will be compressed on the fly, there are some design trade-offs when it comes to performance with incompressible data. SandForce has said that third generation controllers should bring vast improvements to incompressible performance but we have no concrete numbers as of yet.

To test how TRIM behaves with incompressible data, I filled the Force GS with incompressible data and then tortured it with incompressible 4KB random writes (100% LBA space, QD=32) for 60 minutes:

Corsair Force GS—Resiliency—AS SSD—6Gbps
  Read Speed Write Speed
Firmware 5.0.2 5.0.3 5.0.2 5.0.3
Clean 494.1MB/s 507.6MB/s 270.5MB/s 266.8MB/s
After Torture 372.3MB/s 501.1MB/s 74.9MB/s 156.2MB/s
After TRIM 479.8MB/s 506.0MB/s 220.2MB/s 150.3MB/s

With firmware 5.0.2, both read and write speed degrade when tortured. The read speed doesn't degrade as much as write speed, but there is still a clear drop in performance. Fortunately TRIM will mostly restore read performance so there doesn't seem to be a similar problem as with compressible data. Write performance, on the other hand, restores but not fully. After TRIM write performance is about 81% of clean state performance, which isn't bad but not ideal either.

Firmware 5.0.3 seems to bring some changes to how incompressible data is dealt with. TRIM still doesn't work properly but as I've said before, I believe it's the way how the controller and firmware were designed, meaning that there isn't really a way to fix it. The good news is that write speed doesn't degrade nearly as much after torture as it did with firmware 5.0.2. Read speed also stays on-par with clean state performance. On the other hand, TRIM doesn't restore performance at all. As a matter of fact TRIM actually degrades write speed slightly but the difference is small enough to not raise any real concern. We did experience similar behavior with HD Tach, though.


SSD performance is all about trade-offs. As you improve one area, you generally weaken another. For example, you can opt for a large logical block size and get super fast sequential write speeds. The flip side is that random write speed will be horrible. Another good example is SandForce. They have chosen to concentrate on performance with compressible data, which has resulted in a trade-off with incompressible data performance.

Since it's generally impossible to have everything in one package, creating a good firmware and SSD is all about finding the balance. SandForce's approach in firmware 5.0.3 is in the right direction but it's far from perfect. TRIM now restores read speed after torture but in exchange, write speed takes a hit. I'm more satisfied with this behavior because the degradation in write speed is smaller and it seems that sequential writes and idle time will help to restore performance back to clean state. With firmware 5.0.2, read speed degraded for good; TRIMing the drive again and running HD Tach for several times didn't show any improvement.

What I'm more worried about is the TRIM behavior with incompressible data. With 5.0.2, TRIM at least worked somewhat as performance was better after TRIM than after torture. Sure, write speed doesn't go as low as it did with 5.0.2 but since most SSDs are used in TRIM-supported environments, I would rather take worse worst-case performance and partially working TRIM.

Hopefully SandForce will be able to find the right balance in a future firmware, which would be working TRIM regardless of the nature of data. 5.0.3 is a good start, but I feel that it concentrates too much on fixing one problem and as a result creates a bunch of new ones.

Firmware 5.0.3 to the Rescue The Corsair Force GS
Comments Locked


View All Comments

  • bradcollins - Thursday, November 22, 2012 - link

    One question, all of the tests at Anandtech for Sandforce performance after being hammered for a period of time are always over the entire drive. Do the drives maintain their performance if the random writes are only over 50% or 75% of the LBA's on the drive? Very few people actually fill up their SSD so I wonder if it is a truely relevant test?
  • Impulses - Wednesday, November 28, 2012 - link

    You will always eventually use all of your SSD, wear leveling algorithms will spread data across all NAND packages... A certain portion will always be marked "empty" if you haven't filled it to capacity, but that space has been issued and it's subject to the performance degradation conditions AT tests for.
  • Bullwinkle J Moose - Thursday, November 22, 2012 - link

    Time for an article on Cache Analysis?

    It looks to me as though the 1GB Dram Cache on the Intel DC S3700 is mainly responsible for smoothing out those peaks and valleys to deliver "Consistant" performance across the drive

    As for trim.....

    It's time to start with a fresh perspective on SSD's
  • Bullwinkle J Moose - Thursday, November 22, 2012 - link

    I know Intel claimed otherwise on the dram usage, but I don't buy it

    Sounds more likely they are just sending the competition on a wild goose chase
  • Bullwinkle J Moose - Thursday, November 22, 2012 - link

    Reread DC S3700 review again

    256MB of the 1GB is used for cache

    OK, my bad
  • Bullwinkle J Moose - Thursday, November 22, 2012 - link


    If I read it 5 more times I'll get it right eventually
  • extide - Saturday, November 24, 2012 - link

    If it were that easy, don't you think other guys would have drives like the 3700 out?
  • Kristian Vättö - Friday, November 23, 2012 - link

    The problem with caching in general is that there is no good way to test how much write/read caching the drive is doing. All we got is what manufacturers tell us, which may or may not be accurate.
  • mayankleoboy1 - Friday, November 23, 2012 - link

    With each review, Samsung 840Pro looks better and better.
  • JellyRoll - Friday, November 23, 2012 - link

    This information has been already hashed over by several sites, in particular TweakTown. They have been educating the public for months about the lack of TRIM with Sandforce SSDs.
    Other sites have also noticed the read degradation, and commented on it ad nauseum.

Log in

Don't have an account? Sign up now